Steps
1. Using a Phillips #2 screwdriver, remove the screws from the side of the 3.5 inch drive adapter.
2. Remove the drive from the 3.5 inch drive adapter.
Figure 60. Removing a 2.5 inch drive from the 3.5 inch drive adapter
Next steps
Install a 2.5 inch drive into the 3.5 inch drive adapter.
Installing a 2.5 inch drive into the 3.5 inch drive adapter
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Align the screw holes on the 2.5 inch drive with the screw holes on the 3.5 inch drive adapter.
2. Using a Phillips #2 screwdriver, install the screws to secure the drive to the 3.5 inch drive adapter.
108
Installing and removing system components
To Next Page
Loading...
