CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Press the release button, and slide the drive blank out of the drive slot.
Figure 56. Removing a drive blank
Next steps
1. Install a drive or a drive blank
Installing a drive blank
The procedure for installing 2.5 inch and 3.5 inch drive blanks is identical.
Prerequisites
Follow the safety guidelines listed in Safety instructions.
CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 57. Installing a drive blank
Next steps
If removed, install the front bezel.
Installing and removing system components
105
To Next Page
Loading...
