Dell EMC PowerEdge R740xd - Installing Optional IDSDM or Vflash Module

Figure 117. Removing the optional IDSDM/vFlash module
NOTE: There are two dip switches on the IDSDM/vFlash card for write-protection.
Next steps
Install the optional IDSDM/vFlash module.
Installing optional IDSDM or vFlash module
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash connector, see the System board jumpers and connectors section.
2. Align the IDSDM/vFlash card with the connector on the system board.
3. Push the IDSDM/vFlash card until it is firmly seated on the system board.
Installing and removing system components
167