3. Remove the air shroud.
Steps
1. Using Phillips #2 screwdriver, loosen the screws (3) that secure the blank to the system.
2. Press the release tab, and holding the blank by its edges, lift the blank away from the system.
Figure 91. Removing riser 2 and 3 blank
Next steps
Install the riser 2 and 3 blank.
Installing riser 2 and 3 blank
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Align the screw and guide rail on the riser blank with the screw hole and standoff on the system.
2. Lower the blank into the system until the release tab clicks into place.
3. Tighten the screws to secure the riser blank to the system.
Installing and removing system components
145
To Next Page
Loading...
