Dell EMC PowerEdge R740xd - Removing Riser 2 and 3 Blank

Figure 89. Installing expansion card into expansion card riser 2
Figure 90. Installing expansion card into expansion card riser 3
Next steps
1. If applicable, connect the cables to the expansion card.
2. If applicable, install the air shroud.
3. Follow the procedure listed in After working inside your system on page 72.
4. Install any device drivers required for the card as described in the documentation for the card.
Removing riser 2 and 3 blank
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 71.
2. Follow the procedure listed in Before working inside your system on page 72.
144
Installing and removing system components