Figure 118. Installing optional IDSDM/vFlash card
Next steps
1. Install the MicroSD cards.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during
removal.
2. If applicable, install the rear drive cage.
3. If applicable, install the full height PCIe card.
4. Follow the procedure listed in After working inside your system.
Network daughter card
Removing the network daughter card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 71.
2. Follow the procedure listed in Before working inside your system on page 72.
3. If applicable, remove the expansion card riser 2.
4. If applicable, remove the rear drive cage.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
2. Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
3. Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
168
Installing and removing system components
To Next Page
Loading...
