Figure 127. Back view of 12 x 3.5-inch backplane
1. power connector (J_BP_PWR) 2. SAS connector (A2 BP SAS)
3. SAS connector (A1 BP SAS) 4. signal connector (BP SIG1)
5. SAS connector (J_SAS_A0_B0)
Figure 128. Back view of 3.5-inch backplane (mid drive tray)
1.
power connector (J_BP_PWR) 2. SAS connector (J_SAS_A1)
3. signal connector (J_BP_SIG) 4. SAS connector (J_SAS_B1)
5. release tab (2)
Figure 129. Back view of 2.5-inch backplane (rear drive cage)
1. signal connector (J_BP_SIG)
2. power connector (J_BP_PWR_A)
3. SAS connector (J_SAS_1)
Figure 130. Back view of 3.5-inch backplane (rear drive cage)
1.
power connector (J_BP_PWR_A) 2. SAS connector (J_SAS_A)
3. release pin (2) 4. signal connector (J_BP_SIG)
174 Installing and removing system components
To Next Page
Loading...
