Dell Alienware 14 - Removing the Memory Module(s); Prerequisites

16 | Removing the Memory Module(s)
Removing the Memory Module(s)
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. After working inside your computer,
follow the instructions in "After Working Inside Your Computer" on
page 11. For additional safety best practices information, see
the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Prerequisites
1 Remove the base cover. See "Removing the Base Cover" on page 12.
2 Remove the battery. See "Removing the Battery" on page 14.
Procedure
CAUTION: To prevent damage to the memory-module connector, do
not use tools to spread the memory-module securing clips.
1 Using your fingertips, carefully spread apart the securing clips on each end of the
memory-module connector until the memory module pops up.
2 Remove the memory module from the memory-module connector.
1 memory-module connector 2 securing clips (2)
3memory module
1
3
2
book.book Page 16 Monday, June 24, 2013 10:53 AM