Table 20. System setup options—Advanced menu(continued)
Advanced
Default: 2
Auto OS Recovery Threshold Allows you to configure the Auto OS Recovery Threshold.
Default: 2
SupportAssist OS Recovery Allows you to enable or disable the SupportAssist OS Recovery.
Default: Enabled
Table 21. System setup options—Security menu
Security
Unlock Setup Status Displays the unlock setup status.
Admin Password Status Displays whether the admin password is set.
Default: Not Set
System Password Status Displays whether the system password is set.
Default: Not Set
Admin Password Enables the user to set, change, or delete the admin
password.
System Password Enables the user to set, change, or delete the system
password.
Password Change Allows you to enable or disable password change on the
computer.
Default: Permitted
Absolute Enable or disable the BIOS module interface of the
optional Absolute Persistence Module service from Absolute
Software.
Default: Enabled
Firmware TPM Displays the firmware TPM state.
Default: Enabled
PPI Bypass for Clear Command Enable or disable the TPM Physical Presence Interface (PPI).
When enabled, this setting will allow the OS to skip BIOS PPI
user prompts when issuing the Clear command. Changes to
this setting take effect immediately.
Default: Disabled
UEFI Firmware Capsule Updates Enables or disables BIOS updates through UEFI capsule
update packages.
Default: Enabled
Windows SMM Security Mitigations Table (WSMT) Enables or disables Windows SMM Security Mitigation
protections.
Default: Disabled
Enable Pre-Boot DMA Protection Enables or disables Pre-Boot DMA Protection.
Default: Enabled
Enable OS Kernel DMA Support Enables or disables OS Kernel DMA Support.
Default: Enabled
Secure Boot
104
To Next Page
Loading...
