Dell D02X

Table 2. System Conguration
Option Description
Integrated NIC Allows you to congure the integrated network controller. The options are:
• Enable UEFI Network Stack
• Disabled
NOTE: You can use the Disabled option, only if Active Management
Technology (AMT) option is disabled.
• Enabled
• Enabled w/PXE (Default)
Integrated NIC 2 Allows you to congure the integrated network
controller. The options are:
• Enabled (Default)
• Enabled w/PXE
NOTE: This feature is supported only on
Tower 7910.
Serial Port Identies and denes the serial port settings. You can set the serial port to:
• Disabled
• COM1 (Default)
• COM2
• COM3
• COM4
NOTE: The operating system may allocate resources even if the setting is
disabled.
SATA Operation
Tower 7910
Allows you to congure the internal SATA hard-drive controller. The options are:
• Disabled
• ATA
• AHCI (Default)
NOTE: SATA is congured to support RAID mode. No SATA operation
support in Tower 7910.
Drives
Tower 7910
• SATA–0
• SATA–1
Default Setting: All drives are enabled.
NOTE: If the hard drives are connected to a RAID controller card, the hard
drives will display {none} in all the elds. The hard drives can be seen in the
RAID controller card BIOS.
SMART Reporting This eld controls if the hard drive errors for the integrated drives are reported during
system startup. This technology is part of the SMART (Self Monitoring Analysis and
Reporting Technology) specication.
• Enable SMART Reporting - This option is disabled by default.
USB Conguration Allows you to enable or disable the internal USB conguration. The options are:
System Setup 55