Steps
1. Lay the computer on the right side.
2. Slide the release latch to its unlock position and lift the graphics-card end holder away from the PCIe fan.
NOTE: Skip this step if your graphics card does not ship with a graphics-card end holder.
3. Slide the release latch to its unlock position and lift the graphics-card bracket away from the chassis.
NOTE: Skip this step if your graphics card does not ship with a graphics-card end holder.
4. Press the releasing clip on the graphics-card power connectors and disconnect the graphics-card power cables from the
graphics card.
5. Lift the pull tab and open the expansion-card door.
6. Push the securing tab on the PCIe slot away from the graphics card, grasp the card by its top corner, and ease it out of the
slot.
Installing the single-graphics card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the single-graphics card and provide a visual representation of the installation
procedure.
50
Removing and installing components
To Next Page
Loading...
