Steps
1. Align and place the SMA cable connector on the chassis.
2. Route the SMA cable under the PCIe x16 slot.
3. Insert the SMA cable to the securing clip on the system board.
4. Route the SMA cable assembly through the slot on the rear I/O.
5. Replace the washer and nuts that secure the SMA cable connector to the chassis.
Next steps
1. Install the wireless card.
2. Install the single-graphics card.
3. Install the left-side cover.
4. Follow the procedure in After working inside your computer.
Rear-chassis fan
Removing the rear-chassis fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
About this task
The following images indicate the location of the rear-chassis fan and provide a visual representation of the removal procedure.
76
Removing and installing components
To Next Page
Loading...
Need help?
General
