Steps
1. Ensure that the release lever on the processor socket is fully extended and the processor cover is fully open.
CAUTION:
Position the processor correctly in the processor socket to avoid permanent damage to the
processor.
2. Align the pin-1 corner on the processor with the pin-1 corner on the processor socket, and then place the processor in the
processor socket.
CAUTION: Ensure that the processor-cover notch is positioned underneath the alignment post.
3. When the processor is fully seated in the socket, close the processor cover.
4. Push the release lever down and place it under the tab on the processor cover.
Next steps
1. Install the processor liquid-cooling assembly or processor fan and heat-sink assembly, as applicable.
2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
70
Removing and installing components
To Next Page
Loading...
