Dell E525w - Bead-Carry-Out (BCO)

296 Troubleshooting
Fog
Bead-Carry-Out (BCO)
Action Yes No
1 Is the whole page printed light? Contact Dell. Go to action 2.
2 Start Clean Developer.
a Launch the Tool Box , and click Clean Developer on the Printer
Maintenance
tab.
b Click Start .
Is the problem recovered?
The task is complete. Go to action 3.
3 Start Toner Refr esh Mode .
a Launch the Tool Box , and click Ton er Refr es h Mode on the Printer
Maintenance
tab.
b Select the color that is the same as the fog.
Is the problem recovered?
The task is complete. Go to action 4.
4 Start Toner Refr esh Mode again.
Is the problem recovered?
The task is complete. Contact Dell.
Action Yes No
1
If the printer is installed in a high altitude location, set the altitude of
the location.
a Launch the Tool Box , and click Environmental Sensor Info on the
Printer Maintenance tab.
b Click Adjust Altitude .
c Select the value close to the altitude of the location where the printer
is installed.
Is the problem recovered?
The task is complete. Contact Dell.