Steps
1. Disconnect the battery cable from the system board, if it is not previously disconnected.
2. Open the latch and disconnect the hard-drive cable from the system board.
NOTE: This step applies only to computers shipped with a hard drive.
3. Remove the four screws (M2x4) that secure the battery to the palm-rest and keyboard assembly.
4. Lift the battery off the palm-rest and keyboard assembly.
Installing the 3-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the 3-cell battery and provides a visual representation of the installation procedure.
16
Removing and installing components
To Next Page
Loading...
