Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly at an angle, into the memory-module slot.
3. Press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
NOTE: Repeat step 1 to step 3 to install the other memory module, if available on your computer.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Solid-state drive in SSD1 slot
Removing the M.2 2230 solid-state drive from the SSD1
slot
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE:
Depending on the configuration ordered, your computer may support an M.2 2230 solid-state drive or an M.2
2280 solid-state drive in the SSD1 slot.
NOTE: This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed in the SSD1 slot.
The following image indicates the location of the M.2 2230 solid-state drive that is installed in the SSD1 slot and provides a visual
representation of the removal procedure.
Removing and installing components
25
To Next Page
Loading...
