Steps
1. Align the screw hole on the I/O board with the screw hole on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x4) that secure the I/O board to the palm-rest and keyboard assembly.
3. Connect the I/O-board cable to the I/O board and close the latch to secure the cable.
4. Connect the fingerprint-reader cable to the I/O-board and close the latch to secure the cable.
Next steps
1. Install the hard drive.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
G key
Removing the G key
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the rear cover.
4. Remove the rear-cover bracket.
5. Remove the processor fan.
6. Remove the heat sink.
7. Remove the power-adapter port.
About this task
The following image indicates the location of the G key and provides a visual representation of the removal procedure.
Removing and installing components
51
To Next Page
Loading...
