Dell G7 7700 - Installing the Rear-Cover Bracket

2. Remove the base cover.
3. Remove the rear cover.
About this task
The following image indicates the location of the rear-cover bracket and provides a visual representation of the removal procedure.
Steps
1. Remove the four screws (M2x5) that secure the rear-cover bracket to the system board.
2. Lift the rear-cover bracket off the system board.
Installing the rear-cover bracket
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the rear-cover bracket and provides a visual representation of the installation procedure.
42
Removing and installing components