Steps
1. Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
2. Replace the four screws (M2x4) that secure the battery to the palm-rest and keyboard assembly.
3. Connect the hard-drive cable to the system board and close the latch to secure the connection.
NOTE: This step applies only to computers shipped with a hard drive.
4. Connect the battery cable to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing the 6-cell battery
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image indicates the location of the battery and provides a visual representation of the removal procedure.
Removing and installing components
17
To Next Page
Loading...
