Steps
1. Place the display assembly on a clean and flat surface.
2. Place the palm-rest and keyboard assembly on the display assembly.
3. Rotate to close the left and right hinges.
4. Align the screw holes on the display hinges with the screw holes on the palm-rest and keyboard assembly.
5. Replace the two screws (M2.5x4) that secure the left display hinge to the palm-rest and keyboard assembly.
6. Replace the two screws (M2.5x4) that secure the right display hinge to the palm-rest and keyboard assembly.
7. Connect the display cable to the connector on the system board and close the latch.
8. Adhere the tape that secures the display-cable connector latch to the system board.
9. Route the wireless antenna cables through the routing guides on the palm-rest and keyboard assembly.
10. Adhere the tape that secures the wireless antenna cables to the system board.
Next steps
1. Install the base cover for computer shipped with a plastic chassis.
2. Follow the procedure in After working inside your computer.
Removing the display assembly for computers shipped with an
aluminum chassis
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information see, Before working inside your computer.
2. Remove the base cover for computers shipped with an aluminum chassis.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Removing and installing Field Replaceable Units (FRUs)
101
To Next Page
Loading...
