Figure 47. Installing the heat sink
Steps
1. Place the heat sink on the system board.
2. Align the screw holes on the heat sink with the screw holes on the system board.
3. In sequential order (1 > 2 > 3 > 4 > 5 > 6 > 7) tighten the seven captive screws that secure the heat sink to the system
board.
Next steps
1. Install the base cover for computers shipped with an aluminum chassis.
2. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port for computers shipped with a
plastic chassis
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information see, Before working inside your computer.
2. Remove the base cover for computers shipped with a plastic chassis.
74
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
