Figure 43. Connecting the battery cable
Steps
1. Connect the battery cable to the connector on the battery and close the latch.
2. Route the battery cable through the routing guides on the battery.
Next steps
1. Install the 54 W battery for computers shipped with a plastic chassis, or the 54 W battery for computers shipped with an
aluminum chassis.
2. Install the base cover for computers shipped with a plastic chassis, or the base cover for computers shipped with an
aluminum chassis.
3. Follow the procedure in After working inside your computer.
Heat sink
Removing the heat sink for computers shipped with a plastic
chassis - UMA
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information see, Before working inside your computer.
2. Remove the base cover for computers shipped with a plastic chassis.
About this task
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
70 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
