2. Using a plastic scribe, gently pry the camera off the display back-cover and antenna assembly.
3. Remove the camera module from the display assembly.
Installing the camera for computers shipped with a plastic chassis
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the camera module and provide a visual representation of the installation
procedure.
Figure 85. Installing the camera
Steps
1. Using the alignment post, adhere the camera module on the display back-cover and antenna assembly.
2. Connect the display cable to the connector on the camera module.
Next steps
1. Install the display panel for computers shipped with a plastic chassis.
2. Install the display bezel for computers shipped with a plastic chassis.
3. Install the display assembly for computers shipped with a plastic chassis.
4. Install the wireless card for computers shipped with a plastic chassis.
5. Install the M.2 2230 solid-state drive for computers shipped with a plastic chassis.
6. Install the base cover for computers shipped with a plastic chassis.
7. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
117
To Next Page
Loading...
