Display back-cover and antenna assembly
Removing the display back-cover and antenna assembly
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover for computers shipped with a plastic chassis.
3. Remove the M.2 2230 solid-state drive for computers shipped with a plastic chassis.
4. Remove the wireless card for computers shipped with a plastic chassis.
5. Remove the display assembly for computers shipped with a plastic chassis.
6. Remove the display bezel for computers shipped with a plastic chassis.
7. Remove the display panel for computers shipped with a plastic chassis.
8. Remove the camera for computer shipped with a plastic chassis.
About this task
NOTE: The display back-cover and antenna assembly cannot be further disassembled once all the Prerequisites
are completed. If the wireless antennas are malfunctioning and are required to be replaced, replace the entire display
back-cover and antenna assembly.
The image below shows the display back-cover and antenna assembly after the Prerequisites have been performed.
Figure 86. Display back-cover and antenna assembly
118
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
