Next steps
1. Install the display panel for computers shipped with a plastic chassis.
2. Install the display bezel for computers shipped with a plastic chassis.
3. Install the display assembly for computers shipped with a plastic chassis.
4. Install the wireless card for computers shipped with a plastic chassis.
5. Install the M.2 2230 solid-state drive for computers shipped with a plastic chassis.
6. Install the base cover for computers shipped with a plastic chassis.
7. Follow the procedure in After working inside your computer.
Camera
Removing the camera for computers shipped with a plastic chassis
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover for computers shipped with a plastic chassis.
3. Remove the M.2 2230 solid-state drive for computers shipped with a plastic chassis.
4. Remove the wireless card for computers shipped with a plastic chassis.
5. Remove the display assembly for computers shipped with a plastic chassis.
6. Remove the display bezel for computers shipped with a plastic chassis.
7. Remove the display panel for computers shipped with a plastic chassis.
About this task
The following images indicate the location of the camera module and provide a visual representation of the removal procedure.
Figure 84. Removing the camera
Steps
1. Disconnect the display cable from the connector on the camera module.
116
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
