Figure 46. Removing the heat sink
Steps
1. In reverse sequential order (7 > 6 > 5 > 4 > 3 > 2 > 1), loosen the seven captive screws that secure the heat sink to the
system board.
2. Lift the heat sink off the system board.
Installing the heat sink for computers shipped with an aluminum
chassis - Discrete
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the discrete heat sink and provides a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
73
To Next Page
Loading...
