Figure 49. Installing the power adapter port
Steps
1. Place the power-adapter port in its slot on the palm-rest and keyboard assembly.
2. Connect the power-adapter cable to the connector (DC IN1) on the system board.
3. Adhere the tape that secures the power-adapter cable to the system board.
4. Replace the two screws (M2.5x4) that secure the right hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover for computers shipped with a plastic chassis.
2. Follow the procedure in After working inside your computer.
Removing the power-adapter port for computers shipped with an
aluminum chassis
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information see, Before working inside your computer.
2. Remove the base cover for computers shipped with an aluminum chassis.
About this task
CAUTION:
Removing the battery resets the BIOS setup settings to default. It is recommended that you note the
BIOS setup settings before removing the battery.
76 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
