Steps
After performing the Prerequisites, you are left with the display back-cover and antenna assembly.
Installing the display back-cover and antenna assembly
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display back-cover and antenna assembly and provides a visual representation
of the installation procedure.
Figure 87. Display back-cover and antenna assembly
Steps
Place the display back-cover and antenna assembly on a flat surface and perform the Next steps to install the display
back-cover and antenna assembly.
Next steps
1. Install the camera for computers shipped with a plastic chassis.
2. Install the display panel for computers shipped with a plastic chassis.
3. Install the display bezel for computers shipped with a plastic chassis.
4. Install the display assembly for computers shipped with a plastic chassis.
5. Install the wireless card for computers shipped with a plastic chassis.
Removing and installing Field Replaceable Units (FRUs)
119
To Next Page
Loading...
