Figure 81. Installing the screws
Steps
1. Place the display panel and display assembly on a clean and flat surface.
NOTE: Ensure that all cables are properly seated in their routing channels.
2. Connect the display cable to the connector on the display panel and close the latch.
3. Adhere the tape to secure the display cable to the connector on the display panel.
4. Turn the display panel over and place the display panel on the display back-cover.
5. Lift the bottom side of the display panel and slide the top side into the catches at the top of the display back-cover.
6. Slightly bend the bottom corner of the display back-cover and lower the right and left display hinges into the clips on the
display back-cover.
7. Replace the six screws (M2.5x2.5) to secure the display hinges to the display back-cover and antenna assembly.
Next steps
1. Install the display bezel for computers shipped with a plastic chassis.
2. Install the display assembly for computers shipped with a plastic chassis.
3. Install the wireless card for computers shipped with a plastic chassis.
4. Install the M.2 2230 solid-state drive for computers shipped with a plastic chassis.
5. Install the base cover for computer shipped with a plastic chassis.
6. Follow the procedure in After working inside your computer.
Display cable
Removing the display cable for computers shipped with a plastic
chassis
CAUTION: The information in this removal section is intended for authorized service technicians only.
Removing and installing Field Replaceable Units (FRUs) 113
To Next Page
Loading...
