Figure 107. Installing the palm-rest and keyboard assembly
Steps
Place the palm-rest and keyboard assembly on a clean and flat surface.
Next steps
1. Install the system board for computers shipped with a plastic chassis.
2. Install the display assembly for computers shipped with a plastic chassis.
3. Install the touchpad for computers shipped with a plastic chassis.
4. Install the power button for computers shipped with a plastic chassis.
5. Install the heatsink for computers shipped with a plastic chassis.
6. Install the fan for computers shipped with a plastic chassis.
7. Install the speakers for computers shipped with a plastic chassis.
8. Install the I/O board for computers shipped with a plastic chassis.
9. Install the M.2 2230 solid-state drive for computers shipped with a plastic chassis.
10. Install the wireless card for computers shipped with a plastic chassis.
11. Install the battery for computers shipped with a plastic chassis.
12. Install the base cover ffor computers shipped with a plastic chassis.
13. Follow the procedure in After working inside your computer.
Removing the palm-rest and keyboard assembly
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
136
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
