Figure 19. Installing the base cover
Steps
1. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly.
2. Snap the base cover into place.
3. Tighten the two captive screws that secure the base cover to the palm-rest and keyboard assembly.
4. Replace the five screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
Next steps
1. Follow the procedure in After working inside your computer.
Memory module
Removing the memory module for computers shipped with a plastic
chassis
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE:
Ensure that your computer is in Service Mode. For more information, see step 6 in, Before working inside your
computer.
2. Remove the base cover for computers shipped with a plastic chassis.
About this task
The following image indicates the location of the memory module and provides a visual representation of the removal procedure.
44
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
