About this task
NOTE: The support card configuration on the M.2 card slot is:
● M.2 2230 solid-state drive + M.2 2230 solid-state drive mounting bracket
The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the
installation procedure.
Figure 27. Installing the solid-state drive
Steps
1. Place and align the M.2 2230 solid-state drive on the M.2 2230 solid-state drive mounting bracket.
2. Replace the screw (M2x2) that secures the M.2 2230 solid-state drive to the M.2 2230 solid-state drive mounting bracket.
3. Flip over the M.2 2230 solid-state drive assembly.
4. Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 solid-state drive slot on the system board.
5. Slide and place the M.2 2230 solid-state drive in the M.2 solid-state drive slot on the system board.
6. Replace the screw (M2x3) that secures the M.2 2230 solid-state drive assembly to the system board.
Next steps
1. Install the .
2. Install the base cover for computer shipped with an aluminum chassis.
3. Follow the procedure in After working inside your computer.
Wireless card
Removing the wireless card for computers shipped with a plastic
chassis
Prerequisites
1. Follow the procedure in Before working inside your computer.
52
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
