Steps
1. Lift the latch and disconnect the keyboard-backlight cable from the connector (KBBL1) on the system board.
2. Lift the latch and disconnect the keyboard cable from the connector (KB1) on the system board.
3. Lift the latch and disconnect the touchpad cable from the connector (TP1) on the system board.
4. Disconnect the speaker cable from the connector (SPK1) on the system board.
5. Remove the speaker and wireless antenna module cables and from the routing guides on the palm-rest and keyboard
assembly.
6. Lift the left and right speakers along with the cables, off the palm-rest and keyboard assembly.
Installing the speakers for computers shipped with an aluminum
chassis
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
96
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
