About this task
The following image indicates the location of the speakers and provides a visual representation of the installation procedure.
Figure 67. Installing the speakers
Steps
1. Using the alignment posts and rubber grommets, place the speakers on the slots of the palm-rest and keyboard assembly.
NOTE:
Ensure that the rubber grommets on the speakers are threaded through the alignment posts and the four rubber
grommets are seated into the slot and installed on the speakers properly .
2. Route the speaker and wireless antenna module cables through the routing guides on the palm-rest and keyboard assembly.
NOTE: Ensure the wires of the speakers and wireless antennas are placed in their routing guides accordingly.
3. Connect the speaker cable to the connector (SPK1) on the system board.
4. Connect the touchpad cable to the connector (TP1) on the system board and close the latch.
5. Connect the keyboard cable to the connector (KB1) on the system board and close the latch.
6. Connect the keyboard-backlight cable to the connector (KBBL1) on the system board and close the latch.
Removing and installing Field Replaceable Units (FRUs)
97
To Next Page
Loading...
