Figure 22. Removing the memory module
Steps
1. Lift the Mylar to access the memory module.
2. Carefully spread apart the securing-clips on each end of the memory-module slot until the memory module pops-up.
3. Remove the memory module from the memory-module slot on the system board.
Installing the memory module for computers shipped with an
aluminum chassis
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the memory module and provides a visual representation of the installation
procedure.
Removing and installing Customer Replaceable Units (CRUs)
47
To Next Page
Loading...
