Steps
1. Lift the latch and disconnect the touchpad cable from the connector (TP1) on the system board.
2. Lift the latch and disconnect the touchpad cable from the connector on the touchpad.
3. Lift the touchpad cable off the palm-rest and keyboard assembly.
4. Remove the two screws (M2x1.8) and the four screws (M1.6x2.5) that secure the touchpad to the palm-rest and keyboard
assembly.
5. Lift the touchpad off the palm-rest and keyboard assembly.
Installing the touchpad for computers shipped with a plastic
chassis
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the installation procedure.
Figure 61. Installing the touchpad
88
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
