Steps
1. Place the touchpad into its slot on the palm-rest and keyboard assembly.
2. Align the screw holes on the touchpad with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x1.8) and the four screws (M1.6x2.5) that secure the touchpad to the palm-rest and keyboard
assembly.
4. Place the touchpad cable on the palm-rest and keyboard assembly.
5. Connect the touchpad cable to the connector on the touchpad and close the latch.
6. Connect the touchpad cable to the connector (TP1) on the system board and close the latch.
Next steps
1. Install the 41W battery for computers shipped with a plastic chassis, or the 54W battery for computers shipped with a plastic
chassis .
2. Install the base cover for computers shipped with a plastic chassis.
3. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
89
To Next Page
Loading...
