Figure 21. Installing the memory module
Steps
1. Align the notch on the memory module with the tab on the memory-module slot on the system board.
2. Slide the memory module into the memory-module slot on the system board.
3. Press down on the memory module till the securing clips click, locking the memory module in place.
Next steps
1. Install the base cover for computer shipped with a plastic chassis.
2. Follow the procedure in After working inside your computer.
Removing the memory module for computers shipped with an
aluminum chassis
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE:
Ensure that your computer is in Service Mode. For more information, see step 6 in, Before working inside your
computer.
2. Remove the base cover for computers shipped with an aluminum chassis.
About this task
The following image indicates the location of the memory module and provides a visual representation of the removal procedure.
46
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
