Figure 51. Installing the power adapter port
Steps
1. Place the power-adapter port in its slot on the palm-rest and keyboard assembly.
2. Connect the power-adapter cable to the connector (DC IN1) on the system board.
3. Adhere the tape that secures the power-adapter cable to the system board.
4. Rotate to close the right hinge.
5. Replace the two screws (M2.5x4.5) that secure the right hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover for computers shipped with an aluminum chassis.
2. Follow the procedure in After working inside your computer.
I/O board
Removing the I/O board for computers shipped with a plastic
chassis
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information see, Before working inside your computer.
2. Remove the base cover for computers shipped with a plastic chassis.
78
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
