Figure 76. Removing the display bezel
Steps
1. Place the display assembly on a clean, flat surface and gently open the display hinges to at least 90 degrees.
2. Using a plastic scribe, pry open the left display-hinge cap from its right side and pry open the right display-hinge cap from its
left side.
3. Carefully pry open the outer edge of the bottom side of the display bezel.
4. Using the plastic scribe, pry open the outside edge of the left, right, and top sides of the display bezel.
106
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
