Figure 104. Replacing the cable connectors
Figure 105. Replacing the hinge screws
Steps
1. Align the screw holes on the system board with the screw holes on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x2) that secure the system board to the palm-rest and keyboard assembly.
3. Align the screw holes on the USB Type-C bracket to the screw holes on the system board.
4. Replace the two screws (M2x4) that secure the USB Type-C bracket to the system board.
5. Connect the I/O board cable to the connector (IOBD1) on the system board.
6. Connect the speaker cable to the connector (SPK1) on the speaker board.
7. Connect the touchpad cable to the connector (TP1) system board and close the latch.
8. Connect the keyboard cable to the connector (KB1) system board and close the latch.
Removing and installing Field Replaceable Units (FRUs)
133
To Next Page
Loading...
