Figure 35. Installing the fan
Steps
1. Place the system fan on the palm-rest and keyboard assembly.
2. Align the screw holes on the system fan with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x4) that secure the fan to the palm-rest and keyboard assembly.
4. Connect the fan cable (FN1) to the system board.
Next steps
1. Install the base cover for computer shipped with an aluminum chassis.
2. Follow the procedure in After working inside your computer.
Removing and installing Customer Replaceable Units (CRUs)
61
To Next Page
Loading...
