About this task
NOTE: This procedure is applicable only when you are installing a power-button without the optional fingerprint reader.
The following image indicates the location of the power-button with fingerprint reader and provides a visual representation of
the installation procedure.
Figure 59. Installing the power-button with fingerprint reader
Steps
1. Place the power-button into its slot on the palm-rest and keyboard assembly.
2. Align the screw hole on the power-button with the screw hole on the palm-rest and keyboard assembly.
3. Replace the screw (M2x3) that secures the power-button to the palm-rest and keyboard assembly.
Next steps
1. Install the I/O board for computers shipped with an aluminum chassis.
2. Install the base cover for computers shipped with an aluminum chassis.
3. Follow the procedure in After working inside your computer.
86
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
