Removing the stand
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Easel Stand
Steps
1.
CAUTION: Place the computer on a flat, soft, and clean surface to avoid scratches on the display.
Place the computer on a clean and flat surface.
2. Using your fingertips, pry the stand cover off the back cover.
3. Remove the four screws (M3x5) that secure the stand to the system-board shield.
4. Lift and slide the stand from the system-board shield.
3
Removing the stand 11
To Next Page
Loading...
