Replacing the antenna
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
Steps
1. Adhere the antennas to the slot on the display-assembly base.
2. Replace the two screws (M2x2.5) that secure antennas to the display-assembly base.
3. Route the antenna cables through the routing guides on the display-assembly base.
Post-requisites
Steps
1. Replace the wireless card.
2. Replace the system-board shield.
3. Replace the back cover.
4. Replace the stand.
16
Replacing the antenna 29
To Next Page
Loading...
