Replacing the rubber feet
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
Steps
1. Align the screw holes on the rubber feet with the screw holes on the display-assembly base.
2. Replace the four screws (M3x5 black) that secure the rubber feet to the display-assembly base.
Post-requisites
Steps
1. Replace the back cover.
2. Replace the stand.
38
58 Replacing the rubber feet
To Next Page
Loading...
