Dell Inspiron 24 3477 All-in-One - Replacing the stand; Easel stand; Pedestal stand

Replacing the stand
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Easel stand
Steps
1. Insert the tabs on the stand bracket into the slots on the system-board shield.
2. Align the screw holes on the stand with the screw holes on the system-board shield.
3. Replace the four screws (M3x5) that secure the stand to the system-board shield.
4. Replace the stand cover.
5. Place the computer in its upright position.
Pedestal stand
Steps
1. Insert the tabs on the stand bracket into the slots on the system-board shield.
2. Align the screw holes on the stand with the screw holes on the system-board shield.
3. Replace the four screws (M3x5) that secure the stand bracket to the system-board shield.
4. Replace the stand cover.
5. Place the computer in its upright position.
4
Replacing the stand 13