Dell Inspiron 24 3477 All-in-One - Removing the camera

Removing the camera
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
Steps
1. Remove the stand.
2. Remove the back cover.
3. Remove the system-board shield.
Procedure
Steps
1. Disconnect the camera cable from the system board.
2. Remove the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
3. Slide and lift the retractable-camera assembly out of the display-assembly base.
4. Note the routing of the camera cable, and remove it from the routing guides.
5. Press the top of the retractable-camera assembly to extend the retractable camera.
23
36 Removing the camera