Removing the display panel
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
Steps
1. Remove the stand.
2. Remove the back cover.
3. Remove the system-board shield.
Procedure
Steps
1. Peel off the tape that secures the display cable to the connector on the system board.
2. Using your finger tips, push the securing clips on the display cable inwards and disconnect it from the system board.
3. Disconnect the display back-light cable and touch-screen cable (optional) from the display panel.
4. Remove the eight screws (M3x5) that secure the display-assembly base to the display assembly.
5. Place the display-assembly base in its upright position.
6. Push the display panel away from the display-assembly base.
7. Slide the display cable and the touch-screen cable (optional) through the slots on the display-assembly base.
8. Lift the display panel off the display-assembly base.
35
52 Removing the display panel
To Next Page
Loading...
