Removing the system-board shield
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
Steps
1. Remove the stand.
2. Remove the back cover.
Procedure
Steps
1. Remove the five screws (M3x5) that secure the system-board shield to the display-assembly base.
2. Use the handle to lift the system-board shield off the display-assembly base.
9
Removing the system-board shield 19
To Next Page
Loading...
